How To Make a Driftwood Chime In 5 Easy Steps
Driftwood is one of those pieces of beauty. Each piece is unique and if you think about how it was created, it’s just amazing. A fallen tree goes from water to sand to drifting around. Since I love walking around on the beaches and near the rivers I have collected many pieces of driftwood of all different sizes. So I had enough pieces to create a driftwood wind chime DIY. So I counted all the prices of driftwood and has enough to make one,
- Strong Hemp String
- Screw hook
- 2 small screws
Step 1: Gather The Driftwood
Gather all the driftwood you have and make sure they are odd shaped pieces of driftwood. They look best when grouping them. Don’t try to organize them. They need to look uneven when you hang it
Step 2: Drill Hole
Take each driftwood piece and drill a hole in the middle. The driftwood is pretty hard so I used a 1/8 inch drill bit and that created a hole big enough to pass the rope through.
Step 3: Stringing the driftwood
Take a small screw and tie it first before you start threading the rope. It prevents the rope from sliding through the hold. Wet the tip of the rope so it’s easy to pass through the hole. The last piece you need is to tie the second screw at the top and leave at least 5 inches of rope to attach to the screw hook. Use pliers to close the screw hook to avoid the rope from sliding off.
Step 4: Hanging the chime
Screw the hook in the patio ceiling or wherever you are going to hang it. Now you can hang your driftwood chime and it will make pretty sounds in the wind.
Driftwood Candle Holder